1965 Ford GT40 Mark II Prototype
During the 1965 24 Hours of LeMans, Ford received much attention for two large-displacement GT40s entered in the race. These two prototypes were prepared by Kar Kraft, a subsidiary of Ford run by Roy Lunn. They chopped up the GT40 chassis to accept the 427 CID Galaxie engine. Unfortunately, development time on these cars was short and the decision to run them at Le Mans was unexpected.
The initial performance of the 427 GT40 was promising. The car could reach 210 mph down the Mulsanne straight and qualified almost ten seconds faster than any Ferrari. During the opening hours of the race, prototype GT40s were in the lead. Unfortunately transmission problems arose, retiring both cars. Afterwards, it was clear that the 427 GT40 would be the car to race and a more robust transmission was necessary to make the distance.
The 1965 car left many problems which Kar Kraft could not have reversed during their short development time. Although the car was basically the same as the Mark I it had several hundred additional pounds of reinforcing and a longer nose which interfered with aerodynamics. Even though these problems arose, it was decided that the relatively cheap, NASCAR-proven 427 would power the 1966 Mark Two GT40.
Both cars chassis GT/106 and GT/107 were disassembled for their component pieces after Le Mans.
In Detail
submitted by | Richard Owen |
type | Racing Car |
built at | Slough, England |
production | 2 |
engine | Galaxie Watre-Cooled, 90 Degree V8 w/Dry Sump Lubrication |
position | Mid-Longitudinal |
aspiration | Natural |
valvetrain | 2 Valves per Cyl, Pushrod Actuated |
fuel feed | Holley 780cfm 4-Barrel Carburetor |
displacement | 6997 cc / 427.0 in³ |
bore | 108 mm / 4.25 in |
stroke | 96 mm / 3.78 in |
compression | 10.5:1 |
power | 361.7 kw / 485.0 bhp @ 6200 rpm |
specific output | 69.32 bhp per litre |
bhp/weight | 436.54 bhp per tonne |
torque | 644.01 nm / 475.0 ft lbs @ 5000 rpm |
redline | 7400 |
body / frame | Fibreglass Body over Sheet-Steel Semi-Monocoque w/Square Tube Stiffening |
driven wheels | RWD w/LSD |
front tires | 9.75×15 |
rear tires | 12.80×15 |
front brakes | Girling Vented Dicsc |
rear brakes | Girling Vented Dicsc |
front wheels | F 38.1 x 20.3 cm / 15.0 x 8.0 in |
rear wheels | R 38.1 x 24.1 cm / 15.0 x 9.5 in |
steering | Rack & Pinion |
f suspension | Double Wishbones w/Coil Springs, Tube Shocks, Anti-Roll Bar |
r suspension | Transverse Top Link w/Lower Wishbone, Trailing Arms, Coil Springs, Anti-Roll Bar |
curb weight | 1111 kg / 2450 lbs |
wheelbase | 2413 mm / 95.0 in |
front track | 1448 mm / 57.0 in |
rear track | 1448 mm / 57.0 in |
length | 4140 mm / 163.0 in |
width | 1778 mm / 70.0 in |
height | 1028 mm / 40.5 in |
transmission | Ford T44 4-Speed Manual modified by Kar Kraft or ZF 5DS-25 5-Speed Manual |
gear ratios | 2.22:1, 1.43:1, 1.19:1, 1.00:1 |
final drive | 2.77:1 |
top speed | ~337.89 kph / 210 mph |